Laser Cut Tissue Box Cover Generator
Enter the size of your tissue box, or pick a standard one, and get a finger-jointed cover with an oval or slot-shaped opening in the top. The top plate locks in, and the lid and sides can be engraved.
Presets
Tissue box
Measure your tissue box; brands vary by several millimetres.
Added on every side and on top so the cover slips on and off easily.
Opening
Along the long side. At least 3 x the material is kept as wood at each end.
Joints
0 = automatic (about twice the material thickness).
Material
Enter your real sheet thickness; 3 mm plywood is often 2.8 to 3.2. Cut a test corner before the full box.
Personalize
Engrave a name, monogram, message or your own logo on any face. Preview it here for free.
Your first tissue box cover download is free, engraving included.
Fits on 279mm x 385mm sheet (11.0" x 15.2")
- The cover has no bottom: it drops over the tissue box. Refill by lifting the cover off.
- Glue the four walls at the corners, then press the top plate into the wall tops and glue it. Its tabs lock it in, so pulling a tissue cannot lift it.
- Measure your tissue box before cutting; the same brand can change size between packs.
Drag an engraving in the preview to move it.
Good for
- Bathroom and bedroom decor
- Gifts with a name or a pattern on top
- Matching sets with other laser-cut boxes
How it works
- Set the size. Pick a preset or type your own measurements. Every box is drawn to your real material thickness.
- Personalize it. Add a name, a message or an image, drag it into place, and see it on the box before you download.
- Download and cut. The SVG imports at true size in LightBurn, xTool Creative Space and Glowforge. Cut a test corner first if you are unsure of your kerf.
FAQ
Which tissue box sizes are included?
A cube box, a standard rectangular box and a large box. You can also enter your own measurements.
Can I change the opening?
Yes: an oval or a slot, with the size you choose. The tool keeps a strip of wood around it so the top is strong.
How much does it cost?
Your first download of each box type is free, engraving included. After that, 10 exports are $5, or $19 unlocks unlimited downloads for life. An export covers both the SVG and the DXF of the same design, and downloading it again is free.
Does it work with LightBurn, xTool, Glowforge and OMTech?
Yes. The SVG is in millimetres and imports at true size. Cut lines are red and engraving is filled black. The DXF is R12 for RDWorks and CAD software.
What kerf should I use?
Start with 0.15 mm for a CO2 laser or 0.08 mm for a diode, and cut a test corner. Every part is drawn half a kerf oversize so the joints press-fit.
Are my designs and logos uploaded?
No. The boxes, the engraving and any image you add are all handled in your browser. A saved draft stays on your device so your work survives signing in and checking out.
More box types
- Wine box
- Wine bottle sleeve
- Tray
- Organizer box
- Round box
- Birdhouse
- Toolbox
- Carrier box
- Flap-lid box
- Pin-hinge box
Just need a plain box? The free box generator makes finger-joint boxes with five lid types.
